Skip to main content

Hardware Knowledge Base

Start your search by choosing your product and article type:

Discontinuation Notices
Error Codes

CR805/CR825/CE875 - Operator Cleaning Procedures Multihopper Printer

Use the Isopropanol Cleaning Card

Clean the printer with the isopropanol cleaning card each time you change the ink ribbon, or more often if necessary.

Clean a Multi-hopper Printer

1. Remove the ink ribbon and retransfer film cartridges, and the cleaning sleeve. Refer to “Before You Begin” on page 6.
2. Unlock the multi-hopper.
a. Unlock the multi-hopper door lock (a). 
b. Slide the lock bar release button (B1) to the left to release the hopper lock bars (b).
c. Rotate the center lock bar to the left to provide access to the H2 and H5 multi-hopper input cartridges (c)

User-added image

3. Press the cartridge release button at the top of the H2 cartridge and open the cartridge door (d).
4. Lift the card weight to the top of the cartridge and gently pull it forward until it locks in position (e).
5. Remove the unprinted cards from the H2 cartridge (f). Handle the cards by the edges or wear card inspection gloves.

User-added image

6. Open the cleaning card package and remove the isopropanol cleaning card.
7. Peel off the center strips on both sides of the adhesive cleaning card. Leave the side strips in place.

User-added image
8. Load the adhesive cleaning card in the H2 cartridge and close the cartridge door (g). Load the cleaning card in the input hopper. 

User-added image

9. Lock the multi-hopper. 
a. Rotate the center lock bar to the right to the lock position.
b. Slide the lock bar release button to the right to lock the lock bars into place.
c. Lock the multi-hopper door lock.
10. Use the LCD panel to run the isopropanol cleaning card. 

User-added image

When the cleaning cycle completes:
  • If the printer does not have locks: The isopropanol cleaning card is ejected into the output hopper. Remove and discard the cleaning card.
  • If the printer has locks: The isopropanol cleaning card is placed in the printer reject tray (RT1). It can remain in the reject tray until the next time the tray is emptied.
11. Remove the used cleaning card.
a. Unlock the printer and open the printer access door.
b. Remove the used cleaning card from the printer reject tray (RT1).
c. Discard the cleaning card.

12. Install a new cleaning sleeve.

13. Install the ink ribbon and retransfer film.
a. Load new ink ribbon and retransfer film on the cartridges. Refer to the printer’s User’s Guide for complete instructions.
b. Replace the cartridges in the printer.
c. Close and lock the printer access door.

14. Replace the cards in the printer.