Card blocking exit sensors. A card is blocking the Kiosk exit sensors. If an external card reader is connected to the embosser: 1. Set up the external card reader to receive the card. 2. Perform error...
Print ribbon out or missing. The printer does not have usable ribbon. To complete the current card: 1. Open the printer and remove the ribbon cartridge. 2. Install a new ribbon and cleaning roller. 3....
L1 supply problem. The L1 supply is not moving properly. To try another card: 1. Open the laminator and remove the L1 cartridge. 2. Reposition, repair, or replace the supply and advance the repaired a...
Magstripe read no data. The printer did not find any magnetic stripe data on the card. The card will be canceled. 1. Make sure that you are using magnetic stripe cards that match the printer settings....
L1 supply out or missing. The laminator does not have usable supplies. 1. Open the laminator. 2. Replace the supply. 3. Close the laminator. 4. In the Card Printer Driver message, click OK, or click C...
L2 supply type problem. The laminator cannot use the supply installed. Use supplies designed for this laminator.In the Card Printer Driver message, click Retry, or click Cancel to cancel the card.
L2 supply not identified. The laminator cannot use the supply installed. Use supplies designed for this laminator.In the Card Printer Driver message, click Retry, or click Cancel to cancel the card.
Improper shutdown. The printer was not shut down properly. Press and hold the User button to set the printer to Ready. Always use the Power button to power off the printer.Click OK on the PC to clear ...
Magstripe data not found. The printer did not find magnetic stripe data on card. 1. Make sure that you are using magnetic stripe cards that match the printer settings. 2. Make sure that the cards are ...