Card not in position. The card is not positioned in the printer correctly. 1. Open the printer and remove the ribbon cartridge. 2. Turn the knob to remove the card. 3. Replace the ribbon cartridge and...
L1 supply problem. The L1 supply is not moving properly. To try another card: 1. Open the laminator and remove the L1 cartridge. 2. Reposition, repair, or replace the supply and advance the repaired a...
Magstripe read data error. The printer failed to read the magnetic stripe data from the card. The card will be canceled. 1. Make sure that you are using magnetic stripe cards that match the printer se...
L2 area card problem. The card is not where it should be in the laminator. 1. Open the laminator and remove the L2 supply cartridge. 2. Turn the knob to remove the card. 3. Replace the supply cartridg...
Insert new card side 2 up. 1. Turn a new card over end to end so side 2 is facing up. 2. Insert the card in the printer. 3. If the card is not immediately picked, press the printers User button or cli...
L1 area card problem. The card is not where it should be in the laminator. 1. Open the laminator and remove the L1 supply cartridge. 2. Turn the knob to remove the card. 3. Replace the supply cartridg...
Printer problem. The printer had an error. The card will be canceled. 1. Press the printer Power button to power off the printer. 2. Press the Power button again to power on the printer.
Embosser card exit jam. The card path is blocked in the embosser. 1. Open the embosser and remove the supply cartridges. 2. Remove any cards found. 3. Replace the cartridges. 4. Close and lock the emb...
Laminator system mismatch. The printer and laminator are not compatible. The laminator is not supported by your printer model. Contact your service provider for the correct laminator model.