UV ribbon requires LCM. The inserted UV ribbon requires an attached Light Cure Module (LCM) for curing. To resolve the issue: 1. Power off the printer. 2. Attach a rear Light Curing Module. 3. Power o...
RIM Supply Error. A RIM supply problem has occurred or the cassette is out of ribbon. Remove supply cassette and address any issues with the supply or install a new supply cassette.
Close cover to continue. The cover is open or the print ribbon cartridge is missing. Confirm that the print ribbon cartridge is installed and then close the cover.
Laminator exit card problem. The card is not where it should be in the laminator. 1. Open the laminator. 2. Turn the knob to remove the card. 3. Close the laminator. 4. In the Card Printer Driver mess...
Indent ribbon break. The embosser indent ribbon is not moving properly. 1. Open the embosser and remove the indent ribbon cartridge. 2. Reposition, repair, or replace the ribbon and advance the repair...
L1 supply problem. The L1 supply is not moving properly. To try another card: 1. Open the laminator and remove the L1 cartridge. 2. Reposition, repair, or replace the supply and advance the repaired a...
Magstripe data not found. The printer did not find magnetic stripe data on card. 1. Make sure that you are using magnetic stripe cards that match the printer settings. 2. Make sure that the cards are ...
Insert same card side 2 up. 1. Take the card from the printer and turn it over end to end so side 2 is facing up. 2. Insert the card in the printer. 3. If the card is not immediately picked, press the...
