Summary
Laser template error
| Error Message no. | 252 |
| Message text | Laser template error |
| Severity | Critical |
| Recovery Text | There is an error in the ConCAD or image generator template. The laser image data position (also called the turret Z-plane) is out of range. The card will be canceled. Modify the template setup to make sure that the laser image data is correct. |
Summary
Impresser lost card
| Error Message no. | 280 |
| Message text | Impresser lost card |
| Severity | Error |
| Recovery Text | The card cannot be located in the impresser.
|
Summary
Impresser supply error
| Error Message no. | 285 |
| Message text | Impresser supply error |
| Severity | Error |
| Recovery Text | Need to select one of the following descriptions:
|
Summary
Laser setup name length error
| Error Message no. | 269 |
| Message text | Laser setup name length error |
| Severity | Critical |
| Recovery Text | The laser card setup name or element name is too long. Shorten the name as needed. |
Summary
L2 heater sensor problem
| Error Message no. | 214 |
| Message text | L2 heater sensor problem |
| Severity | Critical |
| Recovery Text | The laminator has encountered a critical error. The card will be canceled.
|
Summary
Cloud connection error (Note: This functionality will not be available until D3.17.3)
| Error Message no. | 244 |
| Message text | Cloud connection error (Note: This functionality will not be available until D3.17.3) |
| Severity | Error |
| Recovery Text | The connection to the cloud server failed. |
Summary
Configuration error
Summary
Impresser supply out
| Error Message no. | 282 |
| Message text | Impresser supply out |
| Severity | Warning |
| Recovery Text | The impresser foil is out of material. Install a new supply cartridge. |
Summary
L2 supply not supported
| Error Message no. | 209 |
| Message text | L2 supply not supported |
| Severity | Error |
| Recovery Text | The laminator cannot use the supply installed. Use supplies designed for this laminator. |
Summary
Laser firmware error
| Error Message no. | 259 |
| Message text | Laser firmware error |
| Severity | Critical |
| Recovery Text | The laser had an error. The card will be canceled. 1. Press the printer Power button to power off the printer. 2. Press the Power button again to power on the printer. If the problem occurs again, request service. |
