Card blocking exit sensors. A card is blocking the Kiosk exit sensors. If an external card reader is connected to the embosser: 1. Set up the external card reader to receive the card. 2. Perform error...
Improper shutdown. The printer was not shut down properly. Press and hold the User button to set the printer to Ready. Always use the Power button to power off the printer.Click OK on the PC to clear ...
Insert same card side 2 up. 1. Take the card from the printer. 2. Turn the card over end to end so side 2 is facing up. 3. Insert the card in the printer. 4. If the card is not immediately picked, pre...
Insert new card side 1 up. 1. Insert a new card in the printer with side 1 facing up. 2. If the card is not immediately picked, press the printers User button or click OK.
Print ribbon out or missing. The printer does not have usable ribbon. To complete the current card: 1. Open the printer and remove the ribbon cartridge. 2. Install a new ribbon and cleaning roller. 3....
Print ribbon problem. The print ribbon is not moving properly. 1. Open the printer and remove the ribbon cartridge. 2. Reposition, repair, or replace the ribbon and advance the repaired area one full ...
Magstripe read no data. The printer did not find any magnetic stripe data on the card. The card will be canceled. 1. Make sure that you are using magnetic stripe cards that match the printer settings....
