L1 supply problem. The L1 supply is not moving properly. To try another card: 1. Open the laminator and remove the L1 cartridge. 2. Reposition, repair, or replace the supply and advance the repaired a...
Laminator exit card problem. The card is not where it should be in the laminator. 1. Open the laminator. 2. Turn the knob to remove the card. 3. Close the laminator. 4. In the Card Printer Driver mess...
L2 area card problem. The card is not where it should be in the laminator. 1. Open the laminator and remove the L2 supply cartridge. 2. Turn the knob to remove the card. 3. Replace the supply cartridg...
L1 area card problem. The card is not where it should be in the laminator. 1. Open the laminator and remove the L1 supply cartridge. 2. Turn the knob to remove the card. 3. Replace the supply cartridg...
Laminator entry card problem. The card is not where it should be in the laminator. 1. Open the laminator. 2. Turn the knob to remove the card. 3. Close the laminator. 4. In the Card Printer Driver mes...
Card blocking exit sensors. A card is blocking the Kiosk exit sensors. If an external card reader is connected to the embosser: 1. Set up the external card reader to receive the card. 2. Perform error...
Improper shutdown. The printer was not shut down properly. Press and hold the User button to set the printer to Ready. Always use the Power button to power off the printer.Click OK on the PC to clear ...
Insert same card side 2 up. 1. Take the card from the printer. 2. Turn the card over end to end so side 2 is facing up. 3. Insert the card in the printer. 4. If the card is not immediately picked, pre...
Close cover to continue. The cover is open or the print ribbon cartridge is missing. Confirm that the print ribbon cartridge is installed and then close the cover.
