Waiting for laminator temp. This message does not display. The LCD displays the quot;Warming up xx%quot; message. The printer is waiting for the laminator heaters to reach operating temperature.
Flipper module rotate error. The flipper did not reach the required position. 1. Open the printer access door. 2. Press the K3 rear access door release to open the rear access door. 3. Reach in and ro...
Magstripe data not found. The printer did not find magnetic stripe data on card. 1. Make sure that you are using magnetic stripe cards that match the printer settings. 2. Make sure that the cards are ...
Topping foil out. The embosser does not have usable topping foil. 1. Open the embosser and remove the topping foil cartridge. 2. Install new topping foil. 3. Replace the cartridge, and then close and ...
Indent ribbon supplies out. The embosser does not have usable indent ribbon. 1. Open the embosser and remove the indent ribbon cartridge. 2. Install a new indent ribbon. 3. Replace the cartridge, and ...
Emboss transport error. The card is not correctly positioned in the embosser. 1. Open the embosser and remove the supply cartridges. 2. Remove any cards found. 3. Replace the cartridges, close and loc...
Embosser card entry jam. The card path is blocked in the embosser. 1. Open the embosser and remove the supply cartridges. 2. Remove any cards found. 3. Replace the cartridges, and then close and lock ...
Embosser wheel error. The card path is blocked in the embosser. 1. Open the embosser and remove the supply cartridges. 2. Remove any cards found. 3. Replace the cartridges, and then close and lock the...