L2 supply out or missing. The laminator does not have usable supplies. 1. Open the laminator. 2. Replace the supply. 3. Close the laminator. 4. In the Card Printer Driver message, click OK, or click Cancel to cancel the card.
Printer problem. The printer had an error. The card will be canceled. Press the printer Power button to power off the printer.Press the Power button again to power on the printer.
L2 supply problem. 1. Open the laminator and remove the L2 cartridge. 2. Reposition, repair, or replace the supply and advance the repaired area one full turn. 3. Replace the cartridge and close the laminator. 4. In the Card Printer Driver message, click Retry, or click Cancel to cancel the card.
Magstripe data error. The printer failed to verify that the correct magnetic stripe data was written on the card. 1. Make sure that you are using magnetic stripe cards that match the printer settings. 2. Make sure that the cards are placed in the printer correctly.
Improper shutdown. The printer was not shut down properly. Press and hold the User button to set the printer to Ready. Always use the Power button to power off the printer.Click OK on the PC to clear the message.
Print ribbon problem. The print ribbon is not moving properly. 1. Open the printer and remove the ribbon cartridge. 2. Reposition, repair, or replace the ribbon and advance the repaired area one full turn. 3. Replace the ribbon cartridge and close the printer.
L1 supply type problem. The laminator cannot use the supply installed. Use supplies designed for this laminator.In the Card Printer Driver message, click Retry, or click Cancel to cancel the card.
Card not picked. The printer did not pick a card. To complete the current card: For printers with an input hopper, Open the input hopper.Add or reposition cards.Close the hopper. For printers with single card feed, push the card in until the printer picks it.
