Indent ribbon supplies out. The embosser does not have usable indent ribbon. 1. Open the embosser and remove the indent ribbon cartridge. 2. Install a new indent ribbon. 3. Replace the cartridge, and ...

Laminator entry card problem. The card is not where it should be in the laminator. 1. Open the laminator. 2. Turn the knob to remove the card. 3. Close the laminator. 4. In the Card Printer Driver mes...

Critical problem. The printer had a serious error. The card will be canceled. Press the printer Power button to power off the printer.Request service. The system must remain powered off.

Printer problem. The printer had an error. The card will be canceled. Press the printer Power button to power off the printer.Press the Power button again to power on the printer.

Embosser topper jam. The embosser topping foil is not moving properly. 1. Open the embosser and remove the topping foil cartridge. 2. Reposition, repair, or replace the topping foil. 3. Replace the ca...

Insert cleaning card. 1. Insert cleaning card. 2. If the card is not immediately picked, press the printers User button or click OK.

L1 supply problem. The L1 supply is not moving properly. To try another card: 1. Open the laminator and remove the L1 cartridge. 2. Reposition, repair, or replace the supply and advance the repaired a...

Printer problem. The printer had an error. The card will be canceled. 1. Press the printer Power button to power off the printer. 2. Press the Power button again to power on the printer.

Insert same card side 1 up. 1. Take the card from the printer and turn it over end to end so side 1 is facing up. 2. Insert the card in the printer. 3. If the card is not immediately picked, press the...

Laminator entry card problem. The card is not where it should be in the laminator. 1. Open the laminator. 2. Turn the knob to remove the card. 3. Close the laminator.